Educational link budget, not a certification tool. The coefficients below are typical published figures used as assumptions, not measurements of your cable. Real commissioning needs measured OTDR traces, connector inspection, splice records and the loss limits of the actual transceivers — always confirm against your equipment documentation and your own site standards.
Typical coefficient for this choice: 0.35 dB/km (editable below).
Channel loss
4.90 dB
Received power
-7.90 dBm
Link margin vs Rx
9.10 dB
Total with margin
7.90 dB
Within budget at these assumptions: 9.10 dB of margin above the receiver sensitivity.
Formula: channel loss = (length × attenuation) + (connectors × loss per connector) + (splices × loss per splice). Received power = Tx power − channel loss. Link margin = received power − receiver sensitivity; a margin below 0 dB means the link would not close at these assumptions.
Assumptions used as defaults: single-mode 0.35 dB/km at 1310 nm and 0.22 dB/km at 1550 nm, multimode 3.5 dB/km at 850 nm and 1.5 dB/km at 1300 nm, 0.5 dB per connector, 0.1 dB per fusion splice, and a 3 dB engineering margin. Every figure is editable, and all arithmetic runs in your browser — nothing is measured, queried or sent.